油烟净化器主要用于厨房低空排放油烟的净化治理。当油烟净化器使用一段时间后，由于内部积满了油污，净化处理效果明显下降。因此，在设备试用期间，应及时对油烟净化器进行维护清洗。下面
山东通风管道加工的小编为您讲解油烟净化器日常养护的相关信息。
The oil fume purifier is mainly used for purifying and purifying the cooking fumes emitted from the kitchen at low altitude. When the oil fume purifier was used for a period of time, the purification effect decreased obviously because of the oil contamination inside. Therefore, during the trial period, the oil fume purifier should be cleaned and cleaned in time.
1、清洗的重要性 the importance of cleaning
确保净化器的净化效率；油过多会引起火灾隐患。
Ensure the purifier's efficiency; excessive oil will cause fire hazards.
2、清洗周期 Cleaning cycle
净化器使用两三个月后需要清洗，在厨房油烟较多的情况下应缩短清洗周期，以保证净化器的处理效果。
The purifier should be cleaned after two to three months, and the cleaning cycle should be shortened in the case of more fumes in the kitchen, so as to ensure the treatment effect of the purifier.
3、清洗剂 Cleaning agent
将洗洁精按3%的比例倒入盛有40-50摄氏度的热水清洗槽内搅拌，使之充分溶解。工业烧碱和水按1;15的比例配置所需要清洗剂。油烟净化器专用化学清洗剂。
Pour the detergent into 3% of the hot water cleaning tank with 40-50 degrees Celsius and make it fully dissolved. Industrial caustic soda and water should be allocated 1 to 15 of the required cleaning agent. Special chemical cleaning agent for oil fume purifier.
4、清洗方法 Cleaning method
切断电源，打开检修门；将预处理网拉出；放入清洗槽中浸泡十分钟，轻轻将网上油污清洗干净，并用清水彻底冲洗干净；将清洗后预处理网自然风干；将干燥的预处理网按原位置放回油烟净化器。
Cut off the power supply, open the maintenance door, pull the preconditioning net out, soak in the cleaning tank for ten minutes, gently clean the oil stains on the net, rinse thoroughly with clean water, clean the net naturally after the cleaning, and put the dry pretreatment net back to the oil fume purifier according to the original position.
切断电源，打开检修门，取出电场，用清洁片放在电极板中间，贴着电极板由上向下移动，只需将电极板上大部分油污清理掉即可，一次清理不干净，可以多次清理；清理干净刮下的油污，用清水洗干净；清洗过的电场自然风干；将干燥的电场按原位置放回净化器，关上检修门便可以重新工作。
Cut off the power supply, open the repair door, take out the electric field, use the clean sheet in the middle of the electrode plate, move the electrode plate up and down, only need to clean up most of the oil pollution on the electrode plate, one time clean up not clean, can clean up many times; clean clean shaved oil, wash clean with clear water; clean the natural wind of electric field. Dry; put the dry electric field back to the purifier according to the original position, and then turn on the door to rework.
如想详细咨询相关信息，欢迎访问
山东通风管道加工官网
http://www.jnqsg.com/。
上一篇：通风系统安装注意事项
下一篇：风机叶轮不平衡是什么原因？
