专注通风管道加工·排烟罩

　　1, smoke exhaust pipe of the middle building. The kitchen in the middle building is the same pipe. So the oil inside the kitchen will be transported through the pipeline to the outside, Ji'nan smoke hood for those from the main pipe near the floor, the home kitchen smoke effect is better. Because there is no other effect, and for those away from the main channel of the kitchen, smoke  will be worse.

　　2、低层楼房的排烟管道。这种类型的厨房，可以选择在两墙之间的地方设计排烟口，完全可以顺利排烟。

　　2. Smoke exhaust pipes in low rise buildings. This type of kitchen, you can  choose between the two wall design smoke vent, smoke can be completely smooth.

　　3、高层楼房的排烟管道。高层的厨房排烟管道要求会高一些，厨房排烟的高度好设计在两米四以上，而对于厨房排烟设计出口来说，好是设计成圆形孔状的，而且直径一般在170—200MM之间就可以了。这样就可以确保你厨房的油渍顺利而且又干净的离开你的厨房。

　　3. Smoke exhaust pipe of high-rise building. High rise kitchen exhaust pipe  requirements will be higher, the kitchen smoke exhaust height is good at two meters above four, and for the kitchen smoke design exports, good is designed as a circular hole, and the diameter is generally between 170 - 200MM can be. This will ensure that your kitchen grease is smooth and clean out of your kitchen.

　　厨房内送、排风口的布置应按灶具的具体位置加以考虑，不要让送风射流扰乱灶具的排风性通。确定送风出口的出口风速时，在距地2m左右时的区域风速<0.25m/s较为理想。送风口应沿排风罩方向布置，离开罩子前方小0.7m，而排风口距排风罩越远越好。

　　The arrangement of the air supply and exhaust outlets in the kitchen should  be considered according to the specific location of the cooker, so that the ventilation of the cooker can not be disturbed by the air jet. When determining  the outlet wind speed of the air supply outlet, the area wind speed <0.25m/s is ideal when the distance from the ground is about 2m. The outlet should be arranged in the direction along the hood cover, left in front of a small 0.7m, and the air outlet from the exhaust hood as far as possible.

　　本文的精彩内容来自济南排烟罩详细内容请点击我们的网站:http://www.jnqsg.com/谢谢您的到来!

　　The wonderful content of this article comes from the smoke hood of Ji'nan. Please click on our official website: http://www.jnqsg.com/ thank you for coming!

​

上一篇：通风管道中油烟净化设备的比噪声级
下一篇：油烟净化器的末端必需加装向下的90°弯头